Glossary
Technical terms from the learning guides, briefly explained.
- Bass
- The low range of a sound. In these guides everything below about 250 Hz: bass drum, bass line, the warmth of the sound.
- Bit depth
- How many steps a digital sound has for each value: 16 bits are 65,536 steps, 8 bits only 256. The fewer the steps, the larger the rounding error.
- Bitrate
- How much data per second a lossy format uses for the sound, measured in kbit/s. The lower, the smaller the file and the more is missing.
- Compressor
- A tool that makes loud passages quieter. Afterwards the whole piece can be made louder without overloading. Dynamics are lost in the process.
- Correlation
- Measures how similar the two stereo channels are: +1 identical, 0 independent, −1 opposing. Strongly negative values mean that parts cancel out in mono.
- Crossfeed
- On headphones, mixes a delayed, duller copy of each channel under the other, as happens by itself with speakers.
- Distortion
- An error that follows the sound and adds components that were not there before. It sounds rough or grainy, not like even noise.
- Dither
- A breath of noise added before the rounding. It turns the rounding error into even noise, so quiet sounds stay audible.
- Dynamics
- The distance between the quiet and the loud passages of a piece. If a piece is compressed, it shrinks.
- FLAC
- An open, lossless audio format: the file is smaller than uncompressed and still returns every value.
- Frequency
- How often an oscillation repeats per second, measured in hertz (Hz). Low tones have low frequencies, high tones high ones.
- Highs
- The high range above about 2.5 kHz. It gives shine and clarity, but carries little energy.
- LUFS
- The unit of loudness: Loudness Units relative to full scale. The closer to 0, the louder; a quiet piece sits at −23, a very loud one at −9.
- Lossless
- A format that returns the sound as it was, value for value, for example FLAC. The file is smaller than uncompressed, but not small.
- Lossy
- A format that leaves out parts that the ear hears poorly, for example Opus. The file becomes much smaller, but what was left out does not come back.
- Loudness
- How loud a sound arrives in the ear. It is not measured at the peak, but averaged over the whole piece and weighted according to hearing (ITU-R BS.1770).
- Mids
- The range between bass and highs, here from about 250 Hz to 2.5 kHz. Most instruments and speech lie here.
- Mono
- Both ears hear the same signal. A piece that also sounds good in mono is mono-compatible.
- Noise shaping
- Moves the dither's noise out of the frequencies where the ear is sensitive into higher ones. Overall there is more noise, but it disturbs less.
- Opus
- An open, lossy audio format (RFC 6716) for music and speech, good at low bitrates. PSOrvia has its own encoder and decoder.
- Polarity reversal
- One stereo channel is flipped: it swings against the other. Audible as a missing anchor in the center; in mono, identical parts cancel each other out.
- Quantization
- The rounding of every value to the nearest step of the bit depth. The quieter the sound, the more audible the rounding error.
- Spectrum
- Shows how strongly which frequencies occur in a sound: low on the left, high on the right, loud at the top.
- Stereo
- Two channels, one per ear. Differences between them create the impression of width and space.
- TPDF dither
- Dither with a triangular distribution, the sum of two random values, about one step in size. Its noise is independent of the sound.